Velocity Edge GX440 Guide de l'utilisateur télécharger pdf (Page 374)

ALEOS 4.3.4 Software Configuration User Guide

374 4114514

*MSCIUPADDR Query or set the IP address or FQDN and port that periodic device status updates are

sent to.

AT*MSCIUPADDR[IP address or FQDN][/port]? to query

AT*MSCIUPADDR=[IP address or FQDN][/port] to set

Examples: 192.168.14.100/3333

MyDevice.com/3333

*MSCIUPDPERIOD Query or set the device status update interval (in seconds). Thsi specifies how

frequently the device status update is sent to the port configured in *MSCIUPADDR.

AT*MSCIUPDPERIOD? to query

AT*MSCIUPDPERIOD=n to set

• n=0 — Disabled

• n=1–255 seconds

NSLOOKUP Immediately performs an NSLookup on the supplied FQDN.

ATNSLOOKUP=[FQDN]

*POWERIN? Query the voltage input to the internal hardware.

*RESETCFG AT*RESTCFG resets the device to factory default settings.

Important: There is no confirmation requested. The AT command takes effect

immediately.

*REMOTELOG Exports the log file to a remote destination (Syslog Server). Specifying the port is

option. If the port is not specified, the default port, 514, is used.

AT*REMOTELOG=SYSLOG SERVER IP,PORT

*SECUREMODE Query or set the secure mode that blocks most ports (and ICMP) for over-the-air

(OTA) or OTA and local to prevent unwanted access to the device.

AT*SECUREMODE? to query

AT*SECUREMODE=n to set

• n=0 Off; normal behavior

• n=1 Disables:

• Web management ports (ACEmanager and AVMS access) from the OTA

interface

• Internet Control Message Protocol (ICMP), used for PING, for OTA and Wi-Fi

• n=2 Disables:

• Web management ports from the Over-the-air (OTA) interface

• Internet Control Message Protocol (ICMP) for OTA and Wi-Fi

• ICMP for local ports (Ethernet, USB, and Serial)

Note: Telnet and SSH ALEOS ports remain open regardless of the secure mode

setting. This enables you to connect an AT console to manage the device. DHCP and

DNS ports also remain open to allow the device to provide IP addresses to hosts and

relay the DNS service.

Table 4-14: Admin > Advanced Commands

Command Description

1 2 ... 369 370 371 372 373 374 375 376 377 378 379 ... 411 412

Pas de commentaire

Velocity Edge GX440 Guide de l'utilisateur Page 374